Thingiverse
Basic hinge, 1.75mm filament hole
door texanengineer
4
Downloads
6
Likes
0
Makes
Print out two of these and they'll make a full hinge. Clip out some filament slightly smaller than the width of the hinge, and crimp one end, then thread through the uncrimped end until you can't push anymore. Then, just press down on a solid surface, and you're got a hinge!
Meets dimensions for Butler Tray Hinge Round Edge 2-1/2"x1-1/2" - with Screws
Meets dimensions for Butler Tray Hinge Round Edge 2-1/2"x1-1/2" - with Screws
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!