Basic Plant Elevator / Stand

I wanted to elevate my plants off of their tray so that any extra water / nutrients could drain out and not cause salts to buildup in my soil and lock out nutrients. I couldn't find anything good for a 5 gallon fabric pot on "the 'Verse", so I whipped up my very not perfect version here.

Its a basic grid to hold up the plant, with some slats underneath with a slight angle to hopefully make the drips all go to one place if they're running down the stand so if you want to wipe them off, you can.

I'm using an Ender 3 Pro, but I left the sizing a bit smaller than the bed for my printer. Simply scale it to the size you need, or the largest that will fit on your printer. I've found that scaling it to the largest possible size for my printer fit a 5 gallon fabric pot pretty well.

It takes about 5 hours to print with the settings I used. I'll add pictures as soon as I finish printing it. I don't have supports on at the moment but I may turn them on later.