Slicer Discord
Basic Slim Keyboard and Mice Dock – 3D-printbaar model van Thingiverse Thingiverse

Basic Slim Keyboard and Mice Dock

6 Downloads
12 Likes
0 Makes
Model downloaden
This model fits slim mice and keyboards, i.e. magic keyboard (horizontal or vertical orientation supported) and mouse (horizontal only) from apple, where both can charge on the dock itself.

Keyboard slot currently about 1.2cm wide (just big enough for the magic keyboard, though my logitech k750 fits this as well)

Mouse slot is about 2cm wide, and tall enough to rest on the bumper of a magic mouse when facing outward.


I made this 2 in 1 because I often run out of desk space, and frequently switch between my gaming keyboard and my apple one.

Open to suggestions on sizes.

nits; the mouse slot wall is quite thin at the tallest point, so room for improvement there.

Also the walls are on the thin side, and would not support a gaming keyboard (full metal) without worrying about it breaking, especially in a vertical position.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie