Bass drum pedal

The story behind:
I used Jojo Mayor’s design Perfect Balance to recreate this pedal. All the inspiration was taken from Sonor’s pedal, please make sure you check it out!
Many details are derived, though I had to come up with a new pillar design, suitable for 3d printing. As you can see, it is split into six parts, printed in a way, that ensures strength and minimal layer strain.
The rotating mechanisms of the hoop clamp and footboard had to be replaced with a compliant mechanism (which I do recommend printing in PETG). Unfortunately, footboard compliant joint does not appear to be very long-lasting, so you would probably have to change it.

Recommendations: Before printing all the details, make sure your shafts, bearings, nuts, and screws fit the clearance_test part. The holes for the screws are a bit larger so that you can freely insert them. Keep in mind, that clearance_part should be printed with pretty much the same layer height as in your other parts: making it bigger will re