Bat Signal

This batsignal was designed to be lit. There are holes to run the wires through and the base is large enough to house a battery. The only piece not there is the clear lens for the bat symbol to be attached to. I will just cut out some clear plastic from packaging.

Well, after printing my own I discovered that the connector pieces from the main housing to the bracket were too big. I sanded them down and it fit better. I also found out that ABS doesn't have much flex to it. I did snap one of the bracket pieces trying to get it on. I CA glued it back and it functions fine. Also the back piece ended up printing into two pieces which means I'll just have to glue it on when the time comes. I did delete the old file and replaced it with a new file that should print as one piece.