Thingiverse
bathroom hanger
von alexkv
12
Downloads
18
Likes
0
Makes
This is a hanger for a (bath) towel. The "roundish" design is intended to withstand the situations when the towel is pulled down or pulled to the sides.
The hanger could be attached to / installed on the bathroom walls by using one screw. This design minimizes the numbers of holes to drill ;) Alternatively, one could use double sided tape.
Note: no support structures are required during the 3D printing.
The hanger could be attached to / installed on the bathroom walls by using one screw. This design minimizes the numbers of holes to drill ;) Alternatively, one could use double sided tape.
Note: no support structures are required during the 3D printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
