Thingiverse
Bathroom Sink Organizer
von slyninjafox
10
Downloads
9
Likes
0
Makes
Holds three electric toothbrushes (OralB, battery powered), a flosser dispenser, and a cup dispenser.
This is a prototype. If the cups don't come out, try to sand down the lip until they're able to come out with a little effort. If the hole is too big, they'll just fall out, so I intentionally printed the cup hole a little on the small side.
You will need to print out the holder and the "pick ramp" separately, and glue them together. This was important as otherwise it wouldn't print the dispenser groove properly.
This is a prototype. If the cups don't come out, try to sand down the lip until they're able to come out with a little effort. If the hole is too big, they'll just fall out, so I intentionally printed the cup hole a little on the small side.
You will need to print out the holder and the "pick ramp" separately, and glue them together. This was important as otherwise it wouldn't print the dispenser groove properly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
