Thingiverse
Bathroom Sink Strainer
von cornedbeef
5
Downloads
5
Likes
0
Makes
Bathroom sink plug hole filter to fit 38mm hole.
Can be printed without supports,
Loved the original design by X1Project. However, due to the way it sat on our sink, water flow was really slow.
Modifications done:
- Connected the two top most holes to increase water flow.
- Shortened the lower end to save on filament
WARNING: This remix was not test printed since the print of X1Project's design was physically modified. However, the modifications done (theoretically) should not impact the printing.
Can be printed without supports,
Loved the original design by X1Project. However, due to the way it sat on our sink, water flow was really slow.
Modifications done:
- Connected the two top most holes to increase water flow.
- Shortened the lower end to save on filament
WARNING: This remix was not test printed since the print of X1Project's design was physically modified. However, the modifications done (theoretically) should not impact the printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
