Bathtub/Shower Strainer

This is a compact strainer for bathtubs. Resin-printed versions were much more successful than the earlier FDM versions that I tested. The resin used was Anycubic UV Tough Resin which gets slightly flexible in hot water. Works well, hopefully, it will last a while.

The early version shown in the pictures is included as well as the Rhino 7 files (.3dm).

Update - After 6 months of use, the resin is holding up well. The strainer can get nasty with mildew but it can be cleaned either by soaking it in vinegar or a hot dishwasher cycle.