MakerWorld
Hueforge & Lithophane
Go to Model
Batman hueforge
78
Downloads
37
Likes
29
Makes
Hello everyone! I leave you a story in this case of one of my favorite heroes Batman, I hope you like this type of templates. Oh, by the way, you can rescale the design but not alter the z axis. Thank youBoost Mesi te gusta lo que hago,ya sabes un boost no cuesta nada,gracias.Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x133.33mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 3mm and the Actual Depth is 2.5mmFilaments Used: PLA BambuLab Matte Charcoal PLA BambuLab Matte Ash Gray PLA smartfill blanco frio This print uses 3 unique filamentsSwap Instructions: Start with Charcoal At layer #10 (0.88mm) swap to Ash Gray At layer #20 (1.68mm) swap to blanco frio for the rest.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
