Batman Lightbox

A Batman Lightbox.Just adjust the colors to what you want and go ahead and print! I use Sunlu PLA/PLA+ on a majority of my models and have printed at least 1 of each that I upload successfully from the provided profile.Snap the backplate in after putting the light strip in. It is a tight fit, may have to use a little force. Again, model face down and just put some pressure on it. Would suggest focusing on the small little grooves the most, while trying to keep it even all around.Check out my profile as I have been going on a lightbox creation frenzy and will be uploading more lightboxes as I print them and confirm all's good. I'm just getting into this and by no means an expert. If anyone has any suggestions on slicer settings other than what I have in the default profile, please let me know. I'd appreciate any feedback anyone has or design requests. Also please rate if you like this lightbox!Boost MeLike this print? Throw a boost my way - it'd be greatly appreciated!