Battery Capacity Tester Case

The Geekcreit Battery Capacity Tester module is sold without a case. It can be used without a case, but the internal components will be better protected in some kind of enclosure. Here is my 3D design of a suitable case for the module.

Assembly Care:
- The battery under test (BUT) battery mount needs to be removed from the PCB during assembly, otherwise the board won't be able to slip into position.
- Before soldering the BUT battery mount back into position it will be easier to fit the button extensions into position.
- Finally fit the BUT battery mount into position.
- The text layer is secured in place via thin double sided tape.
- The screws are self taping 3.5mm x 15mm. Two screws are shortened to 8mm and go at the bottom of the case.
- The "+" button extension is partially obstructed by the power switch. Cut a small 1mm incision in the button extension skirt and all will be good.

To make the print result more interesting, I do a filament colour swap near the end s