Thingiverse
Battery case for e-longboard
door Tartopom
37
Downloads
30
Likes
0
Makes
This battery case can be printed in several parts if your printer is not big enough to do it in one time.
It fit 2 batteries pack like this :
Spec.
Capacity: 5000mAh
Voltage: 3S1P / 3 Cell / 11.1V
Discharge: 25C Constant / 35C Burst
Weight: 354g (including wire, plug & case)
Dimensions: 162x21x46mm
Balance Plug: JST-XH
Discharge Plug: 5.5mm Bullet
You can find them on hobbyking.
two packs connected in serie, will make a 6S 5000mah pack.
Should be enough for 10km range.
It fit 2 batteries pack like this :
Spec.
Capacity: 5000mAh
Voltage: 3S1P / 3 Cell / 11.1V
Discharge: 25C Constant / 35C Burst
Weight: 354g (including wire, plug & case)
Dimensions: 162x21x46mm
Balance Plug: JST-XH
Discharge Plug: 5.5mm Bullet
You can find them on hobbyking.
two packs connected in serie, will make a 6S 5000mah pack.
Should be enough for 10km range.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
