Thingiverse
Battery charge indicator
von Scofferoff
2
Downloads
0
Likes
0
Makes
For any rectangular battery, print to the dimensions of the battery and slide over to signify charged and used batteries.
Align the notches with the contacts/wire of the battery, most are not central or are on one side, so remember that to keep track.
Min recommended width: 24mm, to keep the graphics. Any smaller should be resized when slicing 30mm = 15mm at 50% scale etc.
Align the notches with the contacts/wire of the battery, most are not central or are on one side, so remember that to keep track.
Min recommended width: 24mm, to keep the graphics. Any smaller should be resized when slicing 30mm = 15mm at 50% scale etc.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
