Thingiverse
Battery Cover
door Ballistomatic
7
Downloads
17
Likes
1
Makes
This battery cover was designed to replace the cover on an automatic card shuffler, but may work for other devices that use a similar battery cover (for 2x AA batteries).
Print with 0.20mm layer height and supports. After printing, carefully remove the supports. A craft knife can be used to remove the supports without damaging the tabs.
Print with 0.20mm layer height and supports. After printing, carefully remove the supports. A craft knife can be used to remove the supports without damaging the tabs.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
