Thingiverse
Battery hold down bracket
by DennisVdV
3
Downloads
4
Likes
0
Makes
I made this to fit my old Schumacher mission 1 chassis because it is not intended to use with a lipo.
The lipo used is a CNHL hard case.
You can mod this file to fit your car.
The piece in the picture was version 1, the STL file allready is a second version with an extra hole for the balance wire of the hardcase pack.
Also rounded of the ends more.
It is not perfect, but it works.
The lipo used is a CNHL hard case.
You can mod this file to fit your car.
The piece in the picture was version 1, the STL file allready is a second version with an extra hole for the balance wire of the hardcase pack.
Also rounded of the ends more.
It is not perfect, but it works.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
