Battery Mockups

This is an AA battery mockup designed to replace AA batteries with an externalpower source. You will need 2 one-sided PCB pieces. One with a 5 mm diameterand another one with a 9 mm diameter. You will need to print 2 body and attachone PCB piece at the end of each one. The 5 mm PCB piece will act as thenegative pole, while the 9 mm one as the positive pole. Some glue is needed toattach the PCB pieces to the end of the battery mockups. You will also need asoldering iron. You will need to solder a wire to each PCB piece.Support material is not required. An infill of 20% is recommended.This object main web page is: http://www.ctheroux.com/battery-mockups/.This object was designed using Solid Edge Community Edition.You can request the source files on the page listed above.