Battery Pack Cell Holder (Parametric) – 3D printable model from MakerWorld

MakerWorld

Electronics

Battery Pack Cell Holder (Parametric)

by Whity · Electronics

68 Downloads

23 Likes

21 Makes

Go to Model

A widely customizable battery cell holder. To customize it you need Fusion 360, which is free for personal (non-commercial) use. Parameters you can adjust:You may want to set the “GridSpacing” parameter a little smaller than it really is to compensate for the little bump caused by the bridge between the cells during printing. I added STLs for a 8x6 grid (that's what I needed for my project) and a 2x2 grid if you want to test it first. Support my workIf you want to support my work directly, you can buy me a coffee. Also check out my other models.

parametric holder storage battery strip 18650 energy grid ebike cell solar 21700 pack parameterizable backup blackout pv nickel batterycell

Category

Electronics

Source

MakerWorld

Published

21.12.2025

Updated

29.04.2026

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

Software

Cura, PrusaSlicer, or similar

Same designer, more platforms

Whity also publishes on

102 additional models across 1 more platforms

♥ 62,764 ↓ 243,124 ⚒ 2,993

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee

DE EN FR ES IT NL