Thingiverse
Battery Powered LED Flame Bulb Lantern
par redbot
47
Téléchargements
41
Likes
0
Makes
This lantern involves a little bit of everything: laser cutting, 3D printing and simple circuitry.
Requirements:
2.9mm thick sheets: https://smile.amazon.com/gp/product/B07CJY7JK5
2x sets of battery contacts (negative and positive): https://smile.amazon.com/gp/product/B07HRSJ6NX/ - other sizes may also work
1x LED flame bulb: https://smile.amazon.com/gp/product/B07YC8DH7Z - I recommend these from this particular maker because they have the 3 light modes that will still function after clipping the ac dc converter
1x rocker switch: https://smile.amazon.com/gp/product/B07B2S5QYN
4x roughly 5" or 130mm 22-24 gauge wires
Optional: 2x sheets of vellum paper - I used an M3 adhesive spray to apply the paper
2x AA batteries
Instructions:
1) 3D print the base and battery cover - no support needed if using the version with support
2) Strip and solder each wire to a battery contact - 2 negatives and two positives
3) Install a set of contacts to each side of the base in the battery
Requirements:
2.9mm thick sheets: https://smile.amazon.com/gp/product/B07CJY7JK5
2x sets of battery contacts (negative and positive): https://smile.amazon.com/gp/product/B07HRSJ6NX/ - other sizes may also work
1x LED flame bulb: https://smile.amazon.com/gp/product/B07YC8DH7Z - I recommend these from this particular maker because they have the 3 light modes that will still function after clipping the ac dc converter
1x rocker switch: https://smile.amazon.com/gp/product/B07B2S5QYN
4x roughly 5" or 130mm 22-24 gauge wires
Optional: 2x sheets of vellum paper - I used an M3 adhesive spray to apply the paper
2x AA batteries
Instructions:
1) 3D print the base and battery cover - no support needed if using the version with support
2) Strip and solder each wire to a battery contact - 2 negatives and two positives
3) Install a set of contacts to each side of the base in the battery
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
