Battleship working waverider

This is a working battleship wave rider. the design is based off a flowrider. It works with your normal hose outside you house. you may want to hold the part that attaches to the hose and sprays water to start as the quick pressure might push it back. THE PART WHERE THE WATER COMES OUT(NOT THE PART THAT SCREWS INTO THE HOSE) MUST BE PRINTED WITH A .2 NOZZEL. To get the battleship on the sliding rail just place it in the rail sideways and than twist it. This will make a mess so I recommend using it outside. It may take a few seconds for the pressure to fully get threw the hose before working.