Slicer Discord
battletank – 3D printable model from Thingiverse Thingiverse

battletank

1 Downloads
3 Likes
0 Makes
Go to Model
battletank, based on the miniplan tanks, but with a esp32 mini, steering through Dabble (bluetooth) and tires instead of tracks. Program is attached. I made two of them (different turret, different color).
Parts:
- esp32 mini
- L293d motordriver ic
- N20 motors (used 150 rpm here)
- DFplayer mini
- miniature speaker
- L7805 voltage regulator
- common cathode RGB led
- mini servo
- any IR receiver
- IR led
- Lego tires
- axle adapters (https://nl.aliexpress.com/item/1005005339860882.html)
- 7.4 V li-ion battery
- some capacitors and resistors (Voltage regulator and LED)
- 2n3904 transistor to amplify IR signal (see schematics)
- 10K resistor to pullup GPIO35 on the esp32
- a small on/off switch
- power inlet (battery charge)
- epoxy glue to secure the motors and battery
- hotglue to secure wiring
- a little piece of felt (on of those self-adhesive furniture thingys)

Attention points:
- a lot of wiring in a cramped place, so keep your wires as thin and short
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Why?
supports needed
Single piece Supports required
Supports 2/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection