Thingiverse
BB Fidget Spinner
von BBMECH7
42
Downloads
34
Likes
1
Makes
Fidget spinner where the outer ring should be able to press in 3/16" Steel BBs should hold about 30 bbs center bearing is for a 608 (22mm od)
Will likely need supports touching bed but should be ok to produce the outer ring with no supports in it so the bbs can move around.
** Edit **
I can see a few flaws in how this might print. ill check them out a bit more later and post and updated version once they are fixed. Also the fixed version wont need any supports.
**Revised version is now available. This should be printed with the larger flange/ Diameter down and should require no supports.**
Will likely need supports touching bed but should be ok to produce the outer ring with no supports in it so the bbs can move around.
** Edit **
I can see a few flaws in how this might print. ill check them out a bit more later and post and updated version once they are fixed. Also the fixed version wont need any supports.
**Revised version is now available. This should be printed with the larger flange/ Diameter down and should require no supports.**
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
