Cults3D
€ Paid
Tool
Ver Modelo
BBX case type OOO
1
Descargas
0
Likes
0
Makes
A Beyblade box based on the OOO Driver design.
You will need:-3mm plastic rod or copper wire is needed to secure the Beyblade locking part to the case ((3D printed parts may not be strong enough to withstand the pulling force during insertion and removal.)
6 x 6x5mm magnet
A V-shaped spring for the clip
A 3 mm or slightly larger screw for the clip shaft (if you need a larger hole, you will need to drill or ream it out)
*** ooo_box2.stl contains a locking part for Beyblades. There are two types: one with an integrated pin and another with a separate pin that can be replaced with a plastic or metal rod.
https://www.facebook.com/media/set/?set=a.1729837035082249&type=3
You will need:-3mm plastic rod or copper wire is needed to secure the Beyblade locking part to the case ((3D printed parts may not be strong enough to withstand the pulling force during insertion and removal.)
6 x 6x5mm magnet
A V-shaped spring for the clip
A 3 mm or slightly larger screw for the clip shaft (if you need a larger hole, you will need to drill or ream it out)
*** ooo_box2.stl contains a locking part for Beyblades. There are two types: one with an integrated pin and another with a separate pin that can be replaced with a plastic or metal rod.
https://www.facebook.com/media/set/?set=a.1729837035082249&type=3
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
