BD-1 Droid for FDM

Printed the original on my pretty precise FDM printer and just could not get anything to assemble. There was difficulties on how the parts were uploaded getting them flat for printing, fitment was too tight and way too much sanding was required and I still couldn't get most of them to fit.

This is a complete remix and has all of the parts you need. the only untouched parts are the Visor and the Antenna. Everything else has been adjusted for better assembly and minimal if any sanding needed.

This is assembled with the following M3 screws\nuts:

2x M3- 16-18mm (ankles)
1x M3- 18mm (neck to head)
3x M3- 25mm (knees and neck top)
3x M3- 35mm (hips and neck bottom).
9x M3 Lock Nuts

You'll also need a little bit of super glue for those pieces that need to stick together like the pin heads to the pins for the feet. The antenna to antenna ring. Eye ring to eye frame. Antenna mount to head.

There is no need to glue the lo-leg and up-legs together. The screws will hold those