Thingiverse
Beach chair
von arthurverburgh
20
Downloads
17
Likes
0
Makes
I've designed this foldable beach chair for those who want to make an affordable chair with limited tools. The chair exists out of 20 printed pieces, eight broomsticks, and a sail. The total printing time is about 45 hours at .25mm layer height.
Have a nice build and enjoy the sun! If you have any questions feel free to contact me!
Materials:
8x broomsticks 23mm diameter 1400mm long
4x M6 40mm hex bolts
4x RAMPA nuts M6 inner and M11 outer diameter
1x sail or another type of fabric
PLA, ASA, or ABS filament depending on usage and budget. I would recommend ASA because it's stronger, easy to print, and UV resistant. In case you live in a hotter climate the PLA might bend while you are sunbathing. However, I haven't experienced it in Belgium even after extensive use.
Tools:
You'll need a saw to cut the beams, a hand drill or drill press, and a screw driver.
1x 11mm wood drill bit
1x 6mm wood drill bit
The exact measurements for the cutlist of the broomsticks will be
Have a nice build and enjoy the sun! If you have any questions feel free to contact me!
Materials:
8x broomsticks 23mm diameter 1400mm long
4x M6 40mm hex bolts
4x RAMPA nuts M6 inner and M11 outer diameter
1x sail or another type of fabric
PLA, ASA, or ABS filament depending on usage and budget. I would recommend ASA because it's stronger, easy to print, and UV resistant. In case you live in a hotter climate the PLA might bend while you are sunbathing. However, I haven't experienced it in Belgium even after extensive use.
Tools:
You'll need a saw to cut the beams, a hand drill or drill press, and a screw driver.
1x 11mm wood drill bit
1x 6mm wood drill bit
The exact measurements for the cutlist of the broomsticks will be
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
