Thingiverse
Beagleboard XM Case
por alangarf
13
Descargas
2
Likes
0
Makes
This is a Beagleboard Box I created in Fusion 360 for a Rev C board.
I'm using 3mm standoffs to screw the board down and then 3mm screws through the lid to hold the top on. 3mm metal thread screw can screw into the mounts without issue if the infill percentage is high (> 20%) otherwise too much torque may delaminate the mounts.
I'm using 3mm standoffs to screw the board down and then 3mm screws through the lid to hold the top on. 3mm metal thread screw can screw into the mounts without issue if the infill percentage is high (> 20%) otherwise too much torque may delaminate the mounts.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
