Beam3D Prism Cheap Filter Stack

I'm sharing my Beam3D Prism printer exhaust filter after a request from someone in the community. I chose to add a power plug to the rear of the printer, so that I could plug a PC fan into it, but you could use an external power supply, or what have you.

I 3D printed the fan adapter (I lost the original source for the SCAD file), as well as a couple of spacer rings for the trap adapter, but the rest of the parts were either on hand, or from the hardware store. The filters are used FoodCycler filters, from our compost processor, but can be purchased new here: https://www.nofoodwaste.com/products/filters

I did have to cut the fan grill out of the back of the printer. I was able to do it with a pair of side cutters, but be careful if you do it that way, as I have managed to snap cutters doing similar activities in the past. Something like a dremel would be a better choice.

One thing to be mindful, is while I did not glue any of the parts in place, if you do, make sure that the lo