Thingiverse
Bean Case II
door seajseven
14
Downloads
6
Likes
0
Makes
The LightBlue Bean by Punch Through is a small Bluetooth/Arduino board that can do tons of cool stuff.
This is a case that lets you protect it, but is easy to open to get to the battery.
This is a redesign of the Bean Case I made a while back.
I needed a bean case with more internal space for sensors, and thought it would be a good opportunity to start over and pay better attention to fit and printability.
A couple notes:
• Track now has a bevelled design minimizing the overhang. It prints a whole lot better. Slide and lock action was way better for me off the bat compared to v1.
• Inside of case has been extended about 4mm to allow for board add-ons. ( In my case, I'm shoving in a BME280 temp/pressure/humidity sensor and the original case didn't allow for it. )
• Added a modified cap for attaching to metal via 2x 4mm cube magnets.
• Added a modified body with breather holes for environment sensors. ( mostly to look cool )
This is a case that lets you protect it, but is easy to open to get to the battery.
This is a redesign of the Bean Case I made a while back.
I needed a bean case with more internal space for sensors, and thought it would be a good opportunity to start over and pay better attention to fit and printability.
A couple notes:
• Track now has a bevelled design minimizing the overhang. It prints a whole lot better. Slide and lock action was way better for me off the bat compared to v1.
• Inside of case has been extended about 4mm to allow for board add-ons. ( In my case, I'm shoving in a BME280 temp/pressure/humidity sensor and the original case didn't allow for it. )
• Added a modified cap for attaching to metal via 2x 4mm cube magnets.
• Added a modified body with breather holes for environment sensors. ( mostly to look cool )
seajseven publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
