BEAR

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 113.33x170mm in sizeYou may print at higher layer heights below the Min Depth of 0.72mmThe Max Depth is 2.9mm and the Actual Depth is 2.4mmFilaments Used: PLA smartfil negro Transmission Distance: 0.4 PLA smartfil gris Transmission Distance: 0.8 PLA smatfil White Transmission Distance: 6 PLA smartfil marron Transmission Distance: 5 PLA smatfil naranja Transmission Distance: 1.2 PLA smatfil amarillo Transmission Distance: 5.8This print uses 6 unique filamentsSwap Instructions: Start with negro At layer #10 (0.88mm) swap to gris At layer #11 (0.96mm) swap to White At layer #21 (1.76mm) swap to marron At layer #24 (2mm) swap to naranja At layer #25 (2.08mm) swap to amarilloThis slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it. At layer #28 (2.32mm) swap to negro for the rest.