Thingiverse
Bearing Holder
di WarWolfX0
36
Download
25
Likes
0
Makes
I have the Folger Tech RepRap Prusa i3 and upgraded to the
Achatz Dibond Aluminum Y-Carriage Plate.
the Zero Height LM8UU Bearing Holder didn't have enough clearance to pass though the frame with out reshaping the holes. So i created this Bearing Holder. I still had to trim a little from both sides to get it to slide. The Bearing sit on the Y-Carriage Plate and has a stop on one side. The nuts are also recessed and provide a near flush surface.
Print 4
I pickup 2 packs of screws 20-24x1/2 (887480031812) from home depot
Achatz Dibond Aluminum Y-Carriage Plate.
the Zero Height LM8UU Bearing Holder didn't have enough clearance to pass though the frame with out reshaping the holes. So i created this Bearing Holder. I still had to trim a little from both sides to get it to slide. The Bearing sit on the Y-Carriage Plate and has a stop on one side. The nuts are also recessed and provide a near flush surface.
Print 4
I pickup 2 packs of screws 20-24x1/2 (887480031812) from home depot
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
