Thingiverse
Bearing Spool Holder
di KainJoyner73
1
Download
3
Likes
0
Makes
I designed this as I received a 10lb bulk roll of black PLA and had no way of feeding such a large roll to either of my printers.
This has two versions, one for larger printers where each side can be printed in full, and one that is split for smaller printers to print in halves. My prusa is out of commission at the moment, and as such I had to print the split models.
I would suggest adding some form on non-slip item to the base unless you feed your filament from directly above. (i.e, a hole through the top of a cabinet)
This print utilizes the following non-printed parts:
Two 8.1mm internal D, 21.9mm external D, and 6.96mm thick bearings.
And
Two 15mm internal D, 35mm external D, and 11mm thick bearings. (salvaged from ceiling fans)
This has two versions, one for larger printers where each side can be printed in full, and one that is split for smaller printers to print in halves. My prusa is out of commission at the moment, and as such I had to print the split models.
I would suggest adding some form on non-slip item to the base unless you feed your filament from directly above. (i.e, a hole through the top of a cabinet)
This print utilizes the following non-printed parts:
Two 8.1mm internal D, 21.9mm external D, and 6.96mm thick bearings.
And
Two 15mm internal D, 35mm external D, and 11mm thick bearings. (salvaged from ceiling fans)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
