Beat Buddy Mini 2 Extra Button Box

This thing is the switch containment for the two external switches for the Beat Buddy Mini 2 drum machine. It is made to integrate closely with the Beat Buddy casing reliably. The bottom cover is designed to support the stomp buttons when stomped on.

The box should be printed with the top face down on to the bed of the 3D printer. No support needed. Note that one side slants so that it matches the slant on the Beat Buddy case.

All hardware is easily available on Amazon. The male connector is a standard 1/4" TRS (tip, ring, sleeve... i.e., stereo) and the two buttons are momentary, not latching. All that is needed on each is a closed circuit. Two wires from the male TRS connector sleeve to each button. Then a wire from the female connector tip to the other connection on the further button. Then another wire from the female connector ring to the open connection on the closer button. NO resistors are needed at all. I used velcro to attach the bottom to the Beat Buddy just as one wou