Thingiverse
Beaver - Inscryption Cards - Hueforge
by 3DDotDragon
3
Downloads
7
Likes
0
Makes
The 3rd of my triple upload for the day. This one was also kind of difficult to pull off because of the log in his hand. But i think i got the blend good enough.
The Pelts and Holographic cards will be done closer to the end. Ill need to figure out good colors for them.
Feel free to share. The source of the original image can be found in the link below.
https://cards.vladde.me/
Ive been pretty busy making these. However, I dont like uploading files until ive printed it successfully at least once.
This time around im not including the 3mf file and instead you will need to follow the directions of the "_describe.txt" file for instructions on what layers to swap the colors at.
You will need to reduce the size of the model. I would suggest reducing the X and Y by 50%, but make sure to leave Z at 100%. If you modify the Z attribute the instructions will not be valid.
Printing Tips - I would highly suggest reducing the print bed temps from your usual settings when
The Pelts and Holographic cards will be done closer to the end. Ill need to figure out good colors for them.
Feel free to share. The source of the original image can be found in the link below.
https://cards.vladde.me/
Ive been pretty busy making these. However, I dont like uploading files until ive printed it successfully at least once.
This time around im not including the 3mf file and instead you will need to follow the directions of the "_describe.txt" file for instructions on what layers to swap the colors at.
You will need to reduce the size of the model. I would suggest reducing the X and Y by 50%, but make sure to leave Z at 100%. If you modify the Z attribute the instructions will not be valid.
Printing Tips - I would highly suggest reducing the print bed temps from your usual settings when
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
