Thingiverse
Bebop 2 experimental Prop
von 3dbruce
18
Downloads
15
Likes
0
Makes
I was designed a hub tool and also combined a blade with hub I designed for testing on my
Bebop 2. I had a problem today with my Micromake D1 printer. The MB needs replacing now.
I could not complete a print but did complete a partial brim and this shown me it will fit Bebop 2 with no clearance problems.
Note I did not make with center hole a fine drill set might do the trick for now.
Use at your own Risk. this is a non tested blade. rendering ABS yellow should work well.
Bebop 2. I had a problem today with my Micromake D1 printer. The MB needs replacing now.
I could not complete a print but did complete a partial brim and this shown me it will fit Bebop 2 with no clearance problems.
Note I did not make with center hole a fine drill set might do the trick for now.
Use at your own Risk. this is a non tested blade. rendering ABS yellow should work well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
