Thingiverse
BEC Box for Fixed wing
von Apex3D
5
Downloads
1
Likes
0
Makes
Vented BEC box for fixed wing drone.
Version 3 (FW3) Fixed Hole spacing and improved overall design. Added vents on the underside to let air more places for better cooling.
(UPDATE: Somehow I accidentally scaled the holes for the bolts so it works now but doesn't hold the nuts tight.)
Version 2: (FW2) JUNK! Holes are off don't waste time with this one!
Beefed up the floor and overall height of the box. Also put it on a base to bolt it to the underside of the Pixhawk 2 Cube in a fixed wing drone, if you have the space for it.
Version 1:(FW1)
The floor of the box is too thin. well it will work but I think its thin.
Version 3 (FW3) Fixed Hole spacing and improved overall design. Added vents on the underside to let air more places for better cooling.
(UPDATE: Somehow I accidentally scaled the holes for the bolts so it works now but doesn't hold the nuts tight.)
Version 2: (FW2) JUNK! Holes are off don't waste time with this one!
Beefed up the floor and overall height of the box. Also put it on a base to bolt it to the underside of the Pixhawk 2 Cube in a fixed wing drone, if you have the space for it.
Version 1:(FW1)
The floor of the box is too thin. well it will work but I think its thin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
