Bed Level Nut Pad for Flying Bear Ghost 4S

This is a pad or cover for bed leveling knobs. Designed for Flying Bear Ghost 4S. I don't know if it is compatible with the previous Ghosts. But btw it's simple and no need to drill or swap it.

INSTRUCTION:

1. You'll need to print 4 of them
2. Put a bit of superglue into the inner side of a printed part
3. Put it over the knob (remember. The flat side should be on top.)
4. Wait about 1 minute for the glue hardness (you can walk around and drink a cup of tea or coffee :) )
5. Congratulations!!! Now you can easily level your 3d printer's bed.