Bed level probe for Anycubic Kossel

Designed this after seeing the Alien Z Probe http://www.thingiverse.com/thing:820260
The probe sticks too far off the back of the effector making it run into my z-axis belt. Not useful for me but I think the design was good in thought. Perhaps someone else can make this work for them.
To assemble you need:
2 hex nuts I believe they are M4.
1 washer. again not sure of the size.
1 smooth rod bent at 90 degrees which fits cleanly through the hole in the nuts and the washer.
1 small screw.
2 lengths of wire.
1 connector for the 2 wires.
(Sorry for the lack of sizes all the parts used were salvaged from various printers and I built to suit the parts that I had in hand.)