Thingiverse
Bedside Lamp
von Arweli
23
Downloads
11
Likes
0
Makes
A basic, yet neat looking lamp.
With one middle piece and two faders, the lamp stands at 45cm tall. If you leave the middle piece out and with one fader, the lamp will be 23cm tall.
I used normal white LED-strips spun around the middle shafts. One meter for each shaft. (This is hella bright, you can easily use less)
The top part can be printed out with extra top/bottom layers so that the infill doesn't shine through.
The legs were just glued to the bottom.
With one middle piece and two faders, the lamp stands at 45cm tall. If you leave the middle piece out and with one fader, the lamp will be 23cm tall.
I used normal white LED-strips spun around the middle shafts. One meter for each shaft. (This is hella bright, you can easily use less)
The top part can be printed out with extra top/bottom layers so that the infill doesn't shine through.
The legs were just glued to the bottom.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
