Thingiverse
Bee Hive Stopper
von crua9
58
Downloads
28
Likes
0
Makes
Basically, this is a part I made for someone that wanted to stop their bees from going out at given times.
BTW if your filament is about $25 and you do the 5% infill as I suggested. This will cost close to $1 per stick.
BTW if your filament is about $25 and you do the 5% infill as I suggested. This will cost close to $1 per stick.
crua9 veröffentlicht auch auf
68 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!