Thingiverse
Beehive robbing screen clips
door crua9
33
Downloads
31
Likes
0
Makes
This is some clips I made for beehive robbing screens. Basically, screw it on the side of the robbing screen to keep it from falling, and to keep it from where you need a rope or something to hold it on.
Just print 2 out of PETG per screen.
It works by the end is a fraction inwards. I tried to use friction and the spring of the material for this one.
NOTE: The only difference between the 2 is 1 has stars to help transfer the energy, and the other uses normal holes. For the 1, there is 13 stars for the 13 colonies that was in the USA back in the day. I kinda figure why not make it look like one of America's old flags.
Just print 2 out of PETG per screen.
It works by the end is a fraction inwards. I tried to use friction and the spring of the material for this one.
NOTE: The only difference between the 2 is 1 has stars to help transfer the energy, and the other uses normal holes. For the 1, there is 13 stars for the 13 colonies that was in the USA back in the day. I kinda figure why not make it look like one of America's old flags.
crua9 publiceert ook op
67 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
