Beer dart trophy

A friend has a beer dart tournament each year on a camping trip so I designed him a trophy! Its a nice simple print the only issues I ran into was the tip of the dart it is designed as a perfect round so for strength needs printed horizontally. But I did get it to print by dropping it into the bed -.2 this gives it a little bit of a flat side which isn't noticeable. You might have to shave a little of the sides of the tip when removing the brim but other then that it should fit cleanly into the multiple holes I put into the beer can! you can choose where every you want it to inserted. Also the can is hollow so you can put a normal dart into it or inside of it too! Post print clean up supports on the bottom of the can might stick a little but should remove ok, the support bar inside the can is hard to remove I got it with needle nose and worked it around kind of in pieces then pulled it through the mouth of the can an bottom hole. Assembly: print the base & alignment peg, glue peg i