Begode A2 Fairing

Fairing for the begode a2 from heraldomedeiros on Thingiverse that I remixed so you can print flat in 4 parts and mount your pads however you like !

Feel free to remix if you feel the need to. I applied Gorilla tape on the inside section so the parts wouldn't potentially come loose. So far the fairing has held up well with about 4 months of daily commuting in all weathers and lots of off-roading and a few crashes.




TPU 95A Setting

2 walls
4 bottom layers
5 top layers
10% gyroid infill
no support / no brim

Extra

use modifier on the screw holes for thicker wall so when you install the screws thigh, it doesn't compress the fairing in.
Extra point if you used a cool PEI sheet for a nice finish ;)