Thingiverse
Begode Blitz - Rear Pads Extensions
par Rawnei
3
Téléchargements
5
Likes
0
Makes
Rear Pads Extensions for the Begode Blitz, gives you more space to install rear pads so you don't need a complete fairing system if you just need that.
Secured by countersunk M4 screws (3 per side) I used M4x25mm.
Left and Right are individual and can not be mirrored since they have threads.
Printing Instructions:
I've printed these in PLA+, I print with a 0.6 nozzle and will provide perimeter sizes in mm as well for easy conversion.
The tricky part is the support bit, it's essential but you need supports that produce good results and are easy to remove, I will share my essential support settings below, to remove the supports and leave behind a nice flat surface you need to carefully use pliers and possibly also a knife.
Walls: 3 (1.5mm)
Top/Bottom Layers: 3
Infill: 12% Grid
Supports: Yes
Support Pattern: Lines
Support Z Distance: 0.2
Support Interface Density: 50%
Support Interface Pattern: Lines
Secured by countersunk M4 screws (3 per side) I used M4x25mm.
Left and Right are individual and can not be mirrored since they have threads.
Printing Instructions:
I've printed these in PLA+, I print with a 0.6 nozzle and will provide perimeter sizes in mm as well for easy conversion.
The tricky part is the support bit, it's essential but you need supports that produce good results and are easy to remove, I will share my essential support settings below, to remove the supports and leave behind a nice flat surface you need to carefully use pliers and possibly also a knife.
Walls: 3 (1.5mm)
Top/Bottom Layers: 3
Infill: 12% Grid
Supports: Yes
Support Pattern: Lines
Support Z Distance: 0.2
Support Interface Density: 50%
Support Interface Pattern: Lines
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
