Thingiverse
behringer C1 Mic Bracket
von barrysax
0
Downloads
2
Likes
0
Makes
Best printed with 2% , ie %102 in all axis for cura. This allows for PLA+ contraction.
I have adjusted the model so when the nut goes on you can tighten all the way up and the mic can still be turned in the bracket for direction adjustment.
Will need some manual finishing where the supports go.
I have adjusted the model so when the nut goes on you can tighten all the way up and the mic can still be turned in the bracket for direction adjustment.
Will need some manual finishing where the supports go.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!