Thingiverse
Behringer X-Touch Invisible Modular Stand
von RFX01
72
Downloads
60
Likes
2
Makes
This design is a modular fixed-angle stand designed for Behringer X-Touch control surfaces. It can be used to set up an X-Touch along with any amount of Extenders at an angle on your desk.
## Key Features
- Extensible, print more of the same part to support a larger setup
- Very easy to print, no supports or large overhangs
- Invisible, stands are almost completely hidden behind the X-Touch
- Leaves a tiny gap below your X-Touch, just enough for Keyboard/Mouse wires
- Consists of a single part, no assembly required
- Stable, surface can be used without any wobble
You won't need much additional Hardware besides your 3D Printer. The only thing I would recommend are some rubber feet to prevent the control surface from sliding around on your desk. There are six indentations in the bottom of the stand designed to fit rubber feet with a 10mm diameter. If you dont have any, you can print some using TPU or another type of flexible filament and glue them on using superglue or double
## Key Features
- Extensible, print more of the same part to support a larger setup
- Very easy to print, no supports or large overhangs
- Invisible, stands are almost completely hidden behind the X-Touch
- Leaves a tiny gap below your X-Touch, just enough for Keyboard/Mouse wires
- Consists of a single part, no assembly required
- Stable, surface can be used without any wobble
You won't need much additional Hardware besides your 3D Printer. The only thing I would recommend are some rubber feet to prevent the control surface from sliding around on your desk. There are six indentations in the bottom of the stand designed to fit rubber feet with a 10mm diameter. If you dont have any, you can print some using TPU or another type of flexible filament and glue them on using superglue or double
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
