Bell Siphon

Bell Siphon experiment (Work in Progress, currently in pause, experimental)

As some model are fully enclosed it's best to see them with a Slicer like Ultimaker's Cura, or with OpenScad (toggling showtop variable)

Print either with transparent, or shine a light through it.

Print 100% infill, and quite hot to make it water tight, (or waterproof it with wax).

Designed to have a 2d geometry so it can be simulated faster than in 3d, to find the optimal parameters.

I have run simulations with https://github.com/DualSPHysics/DualSPHysics/ simulation needs both water and air so that the siphon works properly.

They are too big (multiple GBs to host on thingiverse)


See following videos :
https://www.youtube.com/watch?v=Yq0zyd64Q04
https://www.youtube.com/watch?v=S748mcM0MSg