Thingiverse
Bell striker - bicycle replacement
por hOZ
0
Descargas
0
Likes
0
Makes
This is a replacement bell striker, intended for use with a bicycle bell with a broken thumb striker.
It can be printed quickly (less than 30 minutes) and easily, only a small section of support is required. I believe it is around 2g of material. It can be adhered onto the bell with glue, I used a 5-minute epoxy.
I hope this is a common bell type, let me know if it does or doesn't work for you. I think some fine tuning of the striker position could be done to improve the ring.
It can be printed quickly (less than 30 minutes) and easily, only a small section of support is required. I believe it is around 2g of material. It can be adhered onto the bell with glue, I used a 5-minute epoxy.
I hope this is a common bell type, let me know if it does or doesn't work for you. I think some fine tuning of the striker position could be done to improve the ring.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
