Thingiverse
Belt guide for PrinterMods.com direct drive kit
por NDCSR
3
Descargas
0
Likes
0
Makes
I had a belt snap on the sharp edge of the PrinterMods.com direct drive kit E plate.
rather than file the edge I printed this up and installed 2 on the belt forks.
it's a little tight but it goes on and stays there.
rather than file the edge I printed this up and installed 2 on the belt forks.
it's a little tight but it goes on and stays there.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
