Belt Pouch - Round

Pouch - Fits with Other pouch in my designs.

I printed this in PLA+, but I can't see why any material wouldn't work just as well.
There are 4 wall's and 100% infill and I printed at a 2mm layer height. The reason I did 100% infill is because I printed these upright which led to a weak area on the molle attachment where it splits from the main body. If I print in the future I may well orient them differently to make that area stronger.

The hinge and clasp holes are designed to take a 3mm bar. This can be printed, but I had 3mm rod in stock so I wanted to use this.

I used supports, but it should only need it for the front bar on the main pouch and the hinge holes as I like to try and save plastic if possible.

There are two version's.
One with a molle attachment that's designed for standard belts like the one pictured. (Note, I made this to fit through two of the three molle sections.)
One has a belt loop for a normal belt.

The pictured pouches are my prototypes so p