Benchy 4in1 Fidget

Just like my shampoo, this bench is a glorious 4-in-1. I printed in with a .8mm nozzle, just because I’m an absolute stud and love speed, but it can be printed with any size other than .6mm. It’s basically print-in-place too. You can print it with the springs flat on the bed, and the only "assembly" you have to suffer through is popping a few pins into place. Some light force is needed to snap the gear pins and hex pins into their homes — a small mallet is ideal, but honestly, anything heavier than 250g (or just a generous amount of elbow grease) will do the job.This model is part of an ongoing contest, so if you think it’s even half as good as I do, a like would be wildly appreciated. Happy printing, you absolute legend.